DMX FAIL MODES
When no DMX signal is received by the DMuX or some other fault condition exists, the letters 'Flt' will appear
in the display.
You may pre-program one of the following options as a response, in case such a fault condition should occur.
See Fig. 3:-
MEM A pre-programmed scene is output.
HOLD The last instruction received is held in the outputs.
CLR Nothing is output.
The current mode is indicated by a dot in the bottom of one of the sections of the display. The mode is
changed by holding down both the + and - buttons together; the dot then scrolls between the sections. When
the dot appears in the appropriate section of the display, hold down STORE until SCE appears in the display.
The mode is now selected and remains in memory until cancelled by re-programming.
To store a scene using the MEM function, first output the scene from your desk or controller. Hold down the
+ and - buttons until the dot appears in the MEM section of the display. Hold down STORE until the letters
SCE appear in the display.
DMuX
LightProcessor DMX Tools, April 2003
Page 4
Fig. 3
