Store
PASS THROUGH MODE
Pass Through mode active is indicated by a dot in the righthand element of the display, labelled
DMX OK.
Valid DMX is being received and the Store is inactive.
MANUAL CONTROL
Manual control active is indicated by a dot in the centre element of the display.
If the DMX signal fails, the Store automatically enters MANUAL MODE and acts according to the
LOSS OF DATA key programmed during configuration.
Alternatively, you may enter MANUAL CONTROL mode by pressing the TAKE CONTROL button.
The Store then outputs the scene shown in the display until it receives a further command.
MOVING BETWEEN SCENES WITH THE AUTO BUTTON
If the AUTO button is pressed, the Store steps to the next valid scene. If any other scene is
selected, the display will flash alternately the number of the current scene and the number of the
next-selected scene. Press AUTO to step to the next-selected scene.
Any programmed fade time is processed; hold times are ignored. When the last programmed
scene or scene 63 is accessed, the next step will be to scene 1.
MOVING BETWEEN SCENES WITH THE SLIDER
Move the slider and the Store fades from the current scene to the next valid scene at the speed
that you move the slider. The display flashes alternately the number of the current scene and the
next scene. The slider LED flashes to show that a fade is in progress when it is between 10% and
90% of its travel.
You may elect to fade to any valid scene. Enter the number of the scene to which you want to
fade. The display flashes alternately the number of the current scene and the desired scene.
During the fade the slider flashes to show that it is active.
Pre-programmed fade and hold times are ignored. When the last programmed scene or scene 63
is accessed, the next fade will be to scene 1.
LightProcessor DMXTools, April 2003
Page 8
TYPE FUNCTION
TO INSTALL TYPE
rST
FAd
Hld
dEL
SoC
End
Sets default values
Set FADE on and allow
adjustment.
Set HOLD on and allow
adjustment.
Delete scene
Start of chase sequence Last
scene in chase sequence
Press STORE until display shows YES
Press STORE. Current FADE value is shown in
display.
Adjust value using slider. Press 4 until display
shows YES to save.
Press 4. Current HOLD value is shown in display.
Adjust value using slider. Press 4 until display
shows YES to save.
Press 4 until display shows YES
Press 4 until display shows YES
Press 4 until display shows YES
