FlightTransport Installation Guide
2-26
505-016300-00000 Rev A
Step 6
Slowly move
one linkhead at a time
in a small back and
forth pattern. If no power indication is seen, turn the tilt
adjuster screw 1/8 turn and repeat the back and forth
pattern. Do this until the low Receive Power indicators on
the front panels go off and you see more than 6 bars of
power on the rear panel indicators on both linkheads.
Start
Stop at largest power
indication
Stop
Once you have end-to-end connectivity, adjust the
alignment until you get the maximum number of power bars
on both ends.
NOTE: Both ends should have almost the same power level
readings – usually within one bar of each other. If both are
not equal, continue to adjust the alignment.
Step 7
Carefully tighten all locking screws on the Pan and Tilt or
Arm Assembly very tight using the hex wrench supplied.
The number of bars that can be seen at the back panel
signal strength meter should not be lower after the locking
screws have been fastened. Repeat the alignment process if
the number of bars is significantly lower on one end of the
system, or if the power indications change as you tighten
the Pan and Tilt or mounting arm assembly.
The alignment procedures are now completed.
2.10.
Network Connections
Step 1
If not already connected as part of the alignment process
(as when using the local power supply) connect the Cat
5/6 copper data cables from the network interface to the
RJ connector on the back of the link head.
Note:
The receive power levels may drop approximately 1 bar
when the network interface fiber optic cables are
attached. This is normal and is not a malfunction.
Step 2
Place the Power Switch to the “ON” Position – up. This will
turn off the test signal generation and begin actual data
transmission across the Free Space link.
Step 3
Confirm that the operational panel indicators are normal
with no alarms or red alarm indications. Refer to Table
2.4.
Step 4
Replace both rear covers and tighten all screws to
weatherproof the units.
The connection procedures are now completed.
Summary of Contents for FlightLite 100
