LightPointe FlightLite 100, Installation And Maintenance Manual

Page: 34 / 59

FlightTransport Installation Guide
2-20 505-016300-00000 Rev A
If it is necessary to lengthen the power cord, another longer
cord may be retrofit to the existing input connector. Open the
power connector by removing the locking ring from the
connector. The prongs on the caps of the protective cover of
the cord can be used to remove the locking ring.
Step 4
Loosen the strain relief on the connector to release the power
cord and detach the power cord wires from the connector.
Place the strain relief over the new power cord, thread the
power cord through the connector and connect the wires of
the power cable to the correct pins of the terminal connector
as indicated on the connector and in the following picture. The
power cord cable outer sheath diameter must be between 5
and 10.25 mm (.19 to .38 inches) in diameter, and the
individual wire connections at the connector plug must be
between .75 mm
2
and 3.31 mm
2
(18 AWG to 12 AWG).
Once the wires have been connected, reassemble the input
power connector. Ensure that the key slot on the terminal
block is properly aligned with the key tab on the connector.
Replace and tighten the locking ring, then connect the power
cord to the AC Input connector.
Cap with
Prongs
Original
Position of
Locking Ring
Locking
Ring
(removed)
Hot
Ground
Neutra