LightPointe FlightLite 100, Installation And Maintenance Manual

Page: 17 / 59

FlightTransport Installation Guide
505-003686-00000 Rev A 2-3
2.1.4. Three methods to power the FL 100
Table 2-1:
Flight
Power Power Supply Options
Power Supply Description
LPS-APOE LightPointe Power Over Ethernet PSE Adaptor
LPL-A12 LightPointe Standard Ruggedized AC Power Supply 90 – 240
VAC, 50/60Hz supplying 12 VDC to the linkhead
Direct ±12 to ±48V
DC The linkhead will accept any DC input voltage from 12 to 48
Volts. If there is a local DC power supply, UPS or battery
plant, power the linkhead from the input pins on the rear
panel using the connector supplied with the linkhead
The most straightforward way to power the linkhead is with the Power
Over Ethernet power inserter. This eliminates the need for AC power
run to the mounting location of the linkhead – often on the roof of the
building.
Figure 2-4: FL 100 Powering Options
Router/Mux/Switch
POE Power
Inserter
(Indoor)
Category 5 UTP
100 – 240VAC
DC Power feed
to Linkhead
Standard
Power
Supply
(Outdoor)
90 – 240VAC or ±
48VDC
Router/Mux/Switch
Category 5 UTP
Power Over Ethernet Powering
LightPointe Standard
Power Supply Powering