LightPointe FlightLite 100, Installation And Maintenance Manual

Page: 32 / 59

FlightTransport Installation Guide
2-18 505-016300-00000 Rev A
Figure 2-11: Wall Power Supply Mounting
Note: The maximum recommended distance between the
power supply box and the linkhead is 3 meters.
Caution: Disconnect main power before connecting
electrical cables.
Step 2
There is a 3-meter power cord provided with the standard AC
power supply. The connector on the cord is pre-wired, and the
cord tail provides three labeled wires (Hot, Neutral and
Ground) that must be properly terminated (junction box,
electrical plug, etc.) for connection to an electrical power
source. LightPointe recommends that the power cord be hard-
wired into a dedicated circuit.
Once the power cord is properly connected to an electrical
source, the power cord connector should be secured to the AC
Input connector on the power supply.
Warning: Ensure that the correct power cable is used.
Exercise extreme caution when affixing the
wires to the connector; incorrect wiring at
the connector can pose personnel hazards
and may cause damage to the equipment
that is NOT covered under warranty.