Lighthouse Handheld 3016 IAQ, Operating Manual

Page: 30 / 136

Lighthouse HANDHELD 3016 IAQ Gen E Operating Manual
4-2 5HY
WARNING:
Do NOT
allow water, solvents, or
other liquids enter the
instrument via the inlet
tube - the instrument will
be damaged and void the
warranty.
Do NOT operate the
instrument with the inlet
tube capped or plugged -
the internal pump will be
damaged and void the
warranty.
10. When the HANDHELD starts counting, “COUNTING” appears
on the display. Particle counts are displayed according to the size
of each particle.
11. If the instrument is in AUTO mode with cycles and a hold time,
“HOLDING” will display after each cycle and “FINISHED” will
display when all the cycles are complete.
12. Press the “STOP” button to stop the instrument before the cycles
are complete.
Touch Screen
Overview
The HANDHELD incorporates a unique touch screen interface to
control and configure the instrument.
Operation Mode
Two modes of operation are available on the HANDHELD 3016 IAQ.
The mode is chosen by toggling the PARTICLE/MASS button circled
in Figure 4-1. This chapter assumes that button reads PARTICLE. Click
the button to change the mode.
Figure 4-1 Particle / Mass Mode Toggle