Activate the Record-Mode:
In order to modify or install programs the unit must be in Record Mode.
To activate record mode:
1. While the unit is turned off, press and hold down the Function
Button (5).
2. Turn the power on while holding down the function button (5).
3. After the unit is turned on, the power LED will flash 5 times indi-
cating record mode has been activated.
Installing the Strobe and Blackout Functions:
1. Turn on a scene via DMX with Shutter = “open”.
2. Press the Function Key until the LED goes on.
3. To store this scene press, the Strobe and Blackout Keys at the
same time. The REC. LED will come on after 3 sec.
4. Push the Blackout Key at the Master Controller. Use the same
scene you used for step 1, Shutter = “open”)
5. Press the Blackout Key at the Auto-Mate/DMX™ the REC. LED will
come on after 3 sec.
6. Switch off the master unitʼs blackout function.
7. Activate the Strobe Function in the same scene. Change only the
DMX channels that activate the Strobe function.
8. Press the Strobe Key at the Auto-Mate/DMX™ Controller. After
three seconds the REC LED will temporarily glow.
Upload Scenes to the Auto-Mate/DMX™
1. Selected a program (1 through 4 ) that will hold your scene (be
sure the function LED is off).
2. With the red function indicator on, choose either Fast (1.4 second
maximum scene hold time) or slow (5.8 second maximum scene
hold time).
3. From your external DMX controller, turn on you are going to send
to the Auto-Mate/DMX.™
4. The default scene hold time is 1/10 of a second. You may use DMX
channel one on your external controller to change the scene hold
time.
- Slider value 10 is equal to one second.
- Slider value 20 is equal to two second.
- Slider value 30 is equal to three second etc...
4. Save scene into memory by pressing the Audio Key, when the
scene has been stored into memory the Rec LED will turn off.
5. Repeat step three and four until you have stored all your desired
scenes or you have reached the maximum of 60 scenes
6. Once you have completed transferring scenes from the external
controller, turn the controller off to exit
Transferring programs between two Auto-Mate/DMX™ units:
This unit allows you to transfer data from Auto-Mate/DMX™ to Auto-
Mate/DMX™ for back-up or data swap purposes. For this procedure you
will need to construct or purchase a male to male 3-pin XLR cable.
1. Link your two units together via the XLR connections on the rear of
each unit.
2. Set both controllers to the Record Mode, see page 11
“Activating
the Record-Mode.”
3. On the “Master” controller, the controller that will act as the send-
ing unit, press the Function Key (5) until the red function LED indi-
cator begins to glow.
4. On the “Master” controller, the sending controller unit, press
both the Fast and Slow function key at the same time. The program
LEDs on both units will begin to flash and chase. This will indicate
programs are being transferred successfully.
5. The process is completed when all the program LEDs stop chas-
ing.
If the data transfer was successful, the same program LEDs will be
glowing on both units. If the same program LED are not on, there was
an upload error. Please repeat this procedure once again.
Auto-Mate/DMX™
Transfer Programs
Auto-Mate/DMX™
Record Mode
©
LSC Supply
®
- www.lightstreamcontrols.com - Auto-Mate/DMX™ Instruction Manual Page 12
©
LSC Supply
®
- www.lightstreamcontrols.com - Auto-Mate/DMX™ Instruction Manual Page 11