LIFT-A-LOFT APX16 - G
ASOLINE
CHAPTER 2
SECTION 3
Page 11
09-26-02
(7) Remove the four bolts securing the driveshaft to the axle companion flange.
(See Driveshaft Removal) Do not allow the parking brake disk to fall. Insert
cardboard wedges between the pads of the parking brake to prevent loss of the
pads.
(8) Remove the bolts securing the shocks to the rear axle.
(9) Support the rear axle. Remove the u-bolts.
(10) Lower the rear axle and pull it out from under the vehicle.
Installation:
(1) Reverse the above procedure for installation.
(2) Bleed the brakes. Be sure to check the fluid level in the reservoir.
11. SHIFTER:
Removal:
(1)
Remove the thumb screws from the
upper edge of the dash and lower it.
(2)
Undo the cable from its mount on the
shifter by removing the nut from the
cable’s swivel end fitting. Be sure to note
and mark its location.
(3)
Remove the bolts securing the shifter unit
to the dash panel.
(4)
Pull the shifter out from the front side of
the dash.
Installation:
(1)
Reverse the above procedure.
(2)
Be sure to install the cable in the same hole from which it was removed.
(3)
Check transmission action before returning the vehicle to service.
Fig 4
Property of American Airlines
