Elevation 95X-ALLXX-01 Commercial Cross-trainer
“How To…”
61
Phillips Screw
Generator
Control Board
HOW TO... REPLACE THE GENERATOR CONTROL BOARD
Tools required: Phillips screwdriver
Estimated time required: 30 minutes
1.
If the cross-trainer has line cords,
unplug them from the wall outlets.
2.
Remove the rear tower rear cover. (See
the “How To…” on page 50.)
3.
Note where each cable to the
generator control board is connected.
This will simplify reassembly.
4.
Disconnect all the cables connected to
the generator control board.
5.
Remove and save the Phillips screw
that secures the generator control
board assembly to the tower.
6.
Install the new generator control board
in reverse order using the hardware
removed and saved in the previous
steps.
Summary of Contents for Elevation 95X-ALLXX-01
Page 1: ...Elevation 95X ALLXX 01 Commercial Cross trainer HOW TO...
Page 2: ......
