Life Fitness ATV15-XXXA-02, Assembly Instructions Manual

Page: 8 / 36

10 11
INSTALLATION
Models: 95T Elevation Discover SI & Explore
Tools Required: Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit: (1) Main Bracket Cap, (1) Grommet
1. Turn off the treadmill and unplug it from the power outlet.
For 95T Elevation Inspire Units Only:
1a. Remove the six screws securing the motor cover. Remove
the motor cover and set it and the screws aside.
1b. Remove the protective liner from one of the provided
fastener strips. Attach the fastener strip to the bottom of
the
POWER BLOCK (1). Interlock the remaining fastener
strip to the installed fastener strip. Remove the remaining
protective liner from fastener strip and secure the power
block to the frame.
1c. Plug the POWER CORDS (2) leading from the motor
compartment and left upright into their respective ends of
the POWER BLOCK (1). Feed excess cable into the left upright.
1d. Re-install the motor cover using the six previously removed screws.
2. Attach the LOWER MOUNTING BRACKET (3) to the MAIN BRACKET (4) using four SCREWS (5) and WASHERS (6)
each. Tighten the screws securely (8-10 ft. lbs.).
3. Slide the NEW BRACKET COVER (7) over the top end of the MAIN BRACKET (4) and down to meet the LOWER
MOUNTING BRACKET (3).
4. Attach the TV BRACKET (with bent tab) (8) to the MAIN BRACKET (4) using four SCREWS (5) and WASHERS (6).
Tighten the screws securely (8-10 ft. lbs.).
7
8
6
5
5
6
3
4
MEDIA CONNECTIONS: PAL / SECAM / DVB-T2
Description Connector Type
Power In 12 Volt DC Power In Power Jack
USB USB Flash Drive USB Type A
High-Definition Input High-Definition Audio & Video Connection High-Definition
VGA In PC-Video Connection VGA
Video In Video In RCA (yellow)
Audio In Stereo Line In RCA (red and white)
S-Video In S-Video Signal In S-Video
RF Coaxial Antenna / Cable Connection RF F-Type
Wired Remote /
Media Cable
Wired Remote Control Connection Remote Control
Audio Out
Headphone Connection 3.5mm stereo jack, 0.3W