24
25
Models: 95X Elevation Discover SI & Explore
Tools Required:
Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit:
(1) Lower Mounting Bracket
For 95X Elevation Inspire Units Only:
a.
Remove the protective liner from one of the provided fastener
strips. Attach the fastener strip to the bottom of the POWER
BLOCK (1). Interlock the remaining fastener strip to the
installed fastener strip. Remove the remaining protective liner
from fastener strip and secure the power block to the under
side of the CENTER FRAME as shown.
Connect
the
SCREW-TYPE CONNECTOR of the POWER
CORD (2) to the underside receptacle. Bundle excess power
cord and store under the unit. Connect the COAXIAL CABLE
(3) to the broadcast supply receptacle in similar fashion.
b.
Connect the POWER CORD (2) to the POWER BLOCK (1).
1. Attach the TV BRACKET
(with bent tab) (
4) to the MAIN BRACKET
(5) as shown using four SCREWS (6) and WASHERS (7). Tighten
the screws securely. (8-10 ft. lbs.)
2. Remove the six SCREWS (8) securing the REAR CONSOLE COVER
(9) to the frame. Remove the rear console cover.
Remove the four SCREWS (10) securing the INSERT (11) as shown.
Set the rear console cover aside.
Remove the CONSOLE (C).
1
3
2
4
7
6
5
11
9
8
10
C
FOR 95X ELEVATION INSPIRE UNITS ONLY:
3.
Cable Routing
3a.
Carefully pull the MEDIA CABLE BUNDLE (12)
(Power and Coaxial)
from inside the CONSOLE BRACKET
(15). Unbundle and straighten the media cables.
3b.
Install the coaxial extension coupler and coaxial extension cable.
3c.
Tape the ends of all CABLES
(Power, Coaxial, I-R Remote Control, Video)
together.
4. Feed the taped end of the MEDIA CABLES (12) through the large hole in the back of the CONSOLE BRACKET (15).
Carefully pull excess media cable through the CONSOLE BRACKET.
5
Slide one GROMMET (16) over the taped end of the MEDIA CABLES (12).
6. Hold the MAIN BRACKET ASSEMBLY (5) close to the CONSOLE BRACKET (15) as shown. With the holes facing up-
ward, feed the taped end of the MEDIA CABLES (12) through the bottom large hole of the main bracket assembly
and out of the upper hole as shown. Carefully pull excess media cable through the main bracket assembly.
7. Slide the remaining GROMMET (16) over the taped end of the MEDIA CABLES (12). Install the grommets into the
access holes.
8. Install the MAIN BRACKET CAPS (19) to the top and bottom of the MAIN BRACKET ASSEMBLY (5).
9. Secure the MAIN BRACKET ASSEMBLY (5) using four SCREWS (17) and WASHERS (18) as shown. Tighten the
screws securely. (8-10 ft. lbs.)
10.
Connect Cables to Console
10a.
Connect the I-R REMOTE CONTROL (A) and VIDEO (B) CABLES to the back of the DISPLAY CONSOLE.
9
19
17
18
16
15
19
95X ELEVATION INSPIRE UNITS ONLY
12
A
B
5
Summary of Contents for ATV15-XXXA-02
Page 1: ...1008767 0001 AA 15 ATTACHABLE TV ASSEMBLY INSTRUCTIONS ...
Page 2: ......
