26
Using printer menus
Emulation Settings
Changes the point size for
scalable typographic fonts.
Point Size:
1.00–1008.00 (12*)
Point size refers to the height of the
characters in the font. One point
equals approximately 1/72 of an inch.
You can select point sizes from 1 to
1008 in increments of 0.25 points.
Note: Point Size is only displayed for
typographic fonts.
Specifies the font pitch for
scalable monospaced fonts.
Pitch:
0.08–100.00 (10*)
Pitch refers to the number of fixed-
space characters in a horizontal inch
of type. You can select a pitch from
0.08 to 100 characters per inch (cpi)
in increments of 0.01 cpi. For
nonscalable monospaced fonts, the
pitch is displayed but cannot be
changed.
Note: Pitch is only displayed for fixed,
or monospaced, fonts.
Determines how text and
graphics are oriented on the
page.
Orientation:
Portrait*
Landscape
Portrait prints text and graphics
parallel to the short edge of the paper.
Landscape prints text and graphics
parallel to the long edge of the paper.
Determines the number of
lines that print on each page.
Lines per Page:
1–255
60* (US)
64* (non-US)
The printer sets the amount of space
between each line (vertical line
spacing) based on the Lines per
Page, Paper Size, and Orientation
menu items. Select the correct Paper
Size and Orientation before changing
Lines per Page.
Sets the width of the logical
page for A4 size paper.
A4 Width:
198 mm*
203 mm
Note: The 203 mm setting makes the
logical page wide enough to print
eighty 10-pitch characters.
Specifies whether the printer
automatically performs a
carriage return after a line
feed control command.
Auto CR after LF:
Off*
On
Off—Printer does not perform a
carriage return after a line feed
control command.
On—Printer performs a carriage
return after a line feed control
command.
Specifies whether the printer
automatically performs a line
feed after a carriage return
control command.
Auto LF after CR:
Off*
On
Off—Printer does not perform a line
feed after a carriage return control
command.
On—Printer performs a line feed after
a carriage return control command.
Menu selection
Purpose
Values
