Removing a printer hard disk
Note:
Use the screwdriver located inside the bottom front door of the printer.
CAUTION—SHOCK HAZARD:
If you are accessing the controller board or installing optional hardware
or memory devices sometime after setting up the printer, then turn the printer off, and unplug the power
cord from the electrical outlet before continuing. If you have any other devices attached to the printer,
then turn them off as well, and unplug any cables going into the printer.
Warning—Potential Damage:
Controller board electronic components are easily damaged by static
electricity. Touch a metal surface on the printer before touching any controller board electronic components
or connectors.
1
Access the controller board.
For more information, see
“Accessing the controller board” on page 21
2
Unplug the hard disk interface cable from the controller board, leaving the cable attached to the hard disk.
To unplug the cable, squeeze the paddle at the plug of the interface cable to disengage the latch before
pulling out the cable.
Additional printer setup
32
