4
Chassis
70
PA1
2020-05-12
S023074
Suspension
WARNING
Do not make changes to any of the suspension and steering components.
You must not cut, drill or weld these components or the mounting brackets
for:
– Steering
– Suspension
– Springs
– Anti-roll bars
– Shock absorbers
– Brakes
WARNING
Do not install components from other LEVC models.
CAUTION
Do not remove the subframes unless you have the correct workshop manual
procedure. Installation of the front and rear subframe requires alignment. Incorrect
aligment of the subframes causes poor handling and increased tyre wear.
CAUTION
Removal and installation of the leaf spring and rear lower control arms requires
special tools. Do not remove the leaf spring or lower control arms unless you have
the correct workshop manual procedure, and the special tools.
CAUTION
If you loosen or remove fasteners, you must tighten them to the correct torque. Refer
to the workshop manual for the correct information.
NOTE
For additional information or technical support contact [email protected].
Wheels and Tyres
Wheels and tyres - General Information
– Do not install wheels or tyres that are not approved by LEVC.
– Do not remove or obstruct the tyre information label on the drivers door pillar.
– Tyres must be inflated to the correct pressures.
– Do not remove the spacers attached to the rear hubs.
NOTE
For additional information or technical support contact [email protected].
