2
Body and Paint
28
PA1
2020-05-12
S023074
Floor Vents
If the conversion includes the installation of floor vents refer to the Drill Zones,
the permitted locations.
Load Space Panels
Bulkhead Panel - LEVC Installed
The bulkhead panel protects the passengers from objects in the load space and improves
security.
Do not obstruct the vent in the bulkhead.
If you need to remove the bulkhead for access to other components you must refer to the
correct procedure in the workshop manual.
NOTE
For additional information or technical support contact [email protected].
Bulkhead Panel - Converter Installed
If the conversion includes the removal, replacement or modification of the bulkhead panel, the
interior motion sensor for the alarm must be switched off. The sensor cannot be configured to
monitor the load space.
NOTE
The interior motion sensor is switched off in vehicles supplied by LEVC without a
bulkhead panel.
A bulkhead panel should be installed to protect the passengers from objects in the load space.
In some countries a bulkhead panel is a legal requirement, it is the converters responsibility to
ensure the conversion obeys local laws and regulations.
If you install a different bulkhead:
– The bulkhead must allow air flow from the passenger compartment to the load space.
– The bulkhead must have a clearance to the vehicle structure to allow the structure to move.
– The bulkhead must not obstruct the movement of the driver and passenger seats.
Fuse Box and Battery Access panel
Do not obstruct access to the fuse box and 12 Volt battery installed on the right side of the
vehicle. Access is necessary for service and maintenance. If you install components that
obstruct removal of the access panel they must be easily removed to prevent increased labour
times and maintenance costs.
To remove the access panel:
1. Remove the fastener and the fuse box access panel.
