Device description
Leuze electronic
LSIS 472i
13
• Device type
•
SW:
Software version
•
HW:
Hardware version
•
SN:
Serial number
• Status displays
• Status display of the switching inputs/outputs
• Display of warnings and errors
• Status information for the device interfaces
• Target/actual position deviation for X- and Y-coordinates in mm
• Statistics
Statistics data for the smart camera:
•
Tested
Number of check program runs since the last time the counter was reset
•
OK
Number of successful check program runs
•
NOK
Number of unsuccessful check program runs
• Position display of the marking (hole or reflector)
1
Actual position of the marking within the capture range
Figure 3.4: Position display
• Parameter
•
Parameter handling
Lock and enable parameter entry on the display
Define password for enabling parameter entry
Reset parameters to factory settings
•
Display settings
Rotate the display 180°
Only possible with enabled parameter entry
•
Program selection
Activation of the check program via the display for compartment fine positioning:
Rack Near
or
Rack Far
•
Ethernet
Configuration of the host and service interface
• Language
Selection of the language used in the display:
German, English, Spanish, French, Italian
• Service
•
Status messages
Only for service purposes by Leuze electronic
•
Commissioning
Selection of the check program and position display for alignment; see chapter 8 "Commissioning"
Teaching-in of the position (teach); see chapter 8.3 "Teaching-in the position"
In Service mode, the device is decoupled from Process mode. Triggering via the switching inputs
is not possible and the digital switching outputs are not set.
1
