Lenovo ThinkSystem SR665, Setup Manual

Page: 150 / 268

Supported drive bay combinations (One processor installed)
The following table shows the supported drive bay combinations when two processors are installed.
Table 27. 3.5-inch drive bay combinations matrix
No. Total drives
Front bays Middle bays Rear bays
3.5'' SAS/SATA 3.5'' SAS/SATA 2.5'' SAS/SATA 3.5'' SAS/SATA
1 8 8
2a 12 12
2b 14 12 2
2c 16 12 4
2d 16 12 4 4
2e 16 12 4
2f 20 12 4 4
Table 28. 2.5-inch drive bay configuration matrix
No.
Total
drives
Front bays Middle bays Rear bays
2.5''SAS/SATA 2.5''NVMe 2.5''SAS/SATA 2.5''SAS/SATA
1 8 8
2 8 8
3 16 8+8
4a 24 8+8+8
4b 28 8+8+8 4
4c 36 8+8+8 4+4 4
4d 40 8+8+8 4+4 8
Note:
For models without any backplanes or drives, field upgrades to other models are available. For details,
check the option part numbers you will need when ordering for different configurations:
Field upgrades
Drive installation requirements
The following notes describe information that you must consider when you install a drive.
• NVMe drives are only supported in the front drive bays (bays 8–11), using the AnyBay backplane (which
offers 4 x NVMe capable drive bays).
• With the 3.5-inch chassis, the middle drive bays are 3.5-inch bays. However, the rear drive bays can be
either 2.5-inch SAS/SATA or 3.5-inch SAS/SATA bays.
• With the 2.5-inch chassis, all drive bays are 2.5-inch bays. No 3.5-inch drives are supported.
• When the front SAS/SATA backplane is connected to PCIe connectors on the system board, only SATA
drives are supported. No SAS drives are supported.
• For the middle/rear drive cage with an NVMe backplane, only 7 mm NVMe drives (installed in the 15 mm-
height drive trays) are supported. The 15 mm drives are not supported.
• To support a middle drive cage:
– Performance fans (speed of 18000 RPM) must be installed.
– The processor TDP must be lower than or equal to 155 watts.
– The ambient temperature must be lower than or equal to 35°C (95°F).
146
ThinkSystem SR665 Setup Guide