Lenovo ThinkServer RD350, User Manual And Hardware Maintenance Manual

Page: 84 / 176

• Use any documentation that comes with the TPM and follow those instructions in addition to the
instructions in this topic.
• Depending on the model, your server might look slightly different from the illustration in this topic.
To install the TPM, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See “Removing or extending the server from the rack cabinet” on page 55.
3. Remove the server cover. See “Removing the server cover” on page 55.
4. Remove the riser card assembly 1 and 2 if needed. See “Replacing the riser card assembly” on
page 122.
5. Touch the static-protective package that contains the TPM to any unpainted surface on the outside of
the server. Then, take the TPM out of the package.
Note: Carefully handle the TPM by its edges.
6. Locate the TPM connector on the system board and then insert the TPM into the TPM connector
on the system board.
Figure 30. Installing the TPM
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 131. Then, you can
configure the TPM function in the Setup Utility program. See “Configuring the TPM function” on page 46.
Removing the TPM
Attention: Do not open your server or attempt any repair before reading and understanding “Safety information”
on page iii and “Guidelines” on page 53.
This topic provides instructions on how to remove the TPM if the server has one installed.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
70
ThinkServer RD350 User Guide and Hardware Maintenance Manual