Lenovo ThinkServer RD350, User Manual And Hardware Maintenance Manual

Page: 146 / 176

4. Ensure that the cover latch is in the open position. Lower the server cover onto the chassis until both
sides of the server cover engage the guides on both sides of the chassis. Then, pivot the cover latch
and slide the cover to the front of the chassis at the same time until the server cover snaps into
position. Ensure that the cover latch is completely closed. Use a screwdriver to turn the cover lock
to the closed position.
Figure 108. Installing the server cover
5. If the server is installed in a rack cabinet, reinstall the server into the rack cabinet. See the Rack
Installation Instructions that comes with the server.
6. Reconnect external cables and power cords to the server. See “Rear view of the server” on page 21 to
identify the connectors on the rear panel of the server.
Attention: To avoid component damage, connect the power cords last.
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will
come with the CRU or will come a few days after the CRU arrives.
Updating the server configuration
When you turn on the server for the first time after you install, remove, or replace a device, you might
need to update the server configuration.
Some optional devices have device drivers that you must install. For information about installing device
drivers, use the documentation that comes with each optional device. To obtain the supported device
drivers for your server from the Lenovo Support Web site, go to http://www.lenovo.com/drivers and follow
the instructions on the Web page to find and download the device drivers you need.
Refer to the following information resources to update the server configuration:
• To update the BIOS configuration, see “Using the Setup Utility program” on page 41.
• To update the RAID configuration, see “Configuring RAID” on page 48.
132
ThinkServer RD350 User Guide and Hardware Maintenance Manual