Lenovo RackSwitch G8264, Command Reference Manual

Page: 650 / 794

650
G8264 Command Reference for ENOS 8.4
evb profile
<1 ‐ 16>
Applies the specified EVB profile for the virtual port.
Command mode: UFP Virtual Port Configuration
no evb profile
Resets the EVB profile for the virtual port.
Command mode: UFP Virtual Port Configuration
network {mode [access|trunk|tunnel|auto|fcoe]|default ­ vlan
<VLAN ID (2 ‐ 4094)>
|default ­ tag}
Configures the virtual port network configuration settings:

mode
configures the virtual port’s operating mode:
•
access
allows the virtual port to associate only with the default
customer VLAN, as defined by the default ‐ vlan option.
•
trunk
allows the virtual port to associate with up to 1024 customer
VLANs depending on the number of virtual ports enabled on the UFP
port.
•
tunnel
makes the virtual port VLAN agnostic.
•
auto
allows the virtual port to be dynamically associated with VLANs
through VMready or QBG.
•
fcoe
configures the virtual port to carry Fibre Channel over Ethernet
traffic when linked to a Fibre Channel virtual Host Bus Adapter.
CEE/FCoE should be enabled globally and priority 3 configured for the
virtual port before enabling an FCoE virtual port.

default ­ vlan
configures the default VLAN ID for the virtual port. This
option provides an override if conflicts arise with a customer VLAN ID on
the upstream network.

default ­ tag
enables tagging egress frames with the default VLAN ID
when the virtual port is in trunk mode and
default ­ vlan
is defined. The
default setting is
disabled
.
Note: VLANs 4002 ‐ 4009 cannot be used as customer VLANs.
Note: A customer VLAN cannot be configured on multiple virtual ports of the
same physical port.
Command mode: UFP Virtual Port Configuration
no network default ­ tag
Disables default VLAN ID tagging on the virtual port.
Command mode: UFP Virtual Port Configuration
Table 371.
UFP Commands (continued)
Command Syntax and Usage