Lenovo 2208, Hardware Maintenance Manual

Page: 115 / 292

4. Remove the hard disk drive from the chassis. See “Replacing the primary hard disk drive” on page
99. Remove the secondary hard disk drive if your model has one. See “Replacing the secondary
hard disk drive” on page 101.
5. Remove all memory modules and PCI cards that are currently installed. See “Installing or replacing a
memory module” on page 84 and “Installing or replacing a PCI card” on page 81.
6. Carefully take note of the locations of all cable connections on the system board and disconnect all
the cables. See “Locating parts on the system board” on page 77.
7. Remove the heat sink and fan assembly from the failing system board. See “Replacing the heat sink and
fan assembly” on page 95.
8. Remove the eight screws that secure the system board.
Figure 45. Removing the eight screws that secure the system board
9. Carefully slide the system board so that it can be released from the mounting studs that secure the
system board in place.
10. Lift the system board out of the chassis.
11. Remove the microprocessor from the failing system board and install it on the new system board.
See “Replacing the microprocessor” on page 97.
12. Install the new system board into the chassis by aligning the eight mounting studs in the chassis with the
corresponding holes in the new system board. Carefully slide the new system board into the chassis until
it is secured in place by the mounting studs. Then, install the eight screws to secure the system board.
13. Install the heat sink and fan assembly and connect the heat sink and fan assembly cable to the new
system board. See “Replacing the heat sink and fan assembly” on page 95.
14. Install all memory modules and PCI cards removed from the failing system board on the new system
board. See “Installing or replacing a memory module” on page 84 and “Installing or replacing a PCI
card” on page 81.
Chapter 8
.
Replacing FRUs (Machine Types: 1982, 1983, 1985, 1986, 1987, 1990, 1992, 1993, 1994, and 1995.)
111