Lenovo 2208, Hardware Maintenance Manual

Page: 112 / 292

Note: Make sure you note the locations of the cables when you disconnect the cables from the system
board.
6. Remove the screw that secures the front audio and USB assembly bracket to the chassis to remove
the bracket from the chassis.
Figure 42. Removing the screw that secures the front audio and USB assembly to the chassis
7. Remove the two screws that secure the front audio and USB assembly to its bracket and remove the
failing front audio and USB assembly from the bracket.
8. Install a new front audio and USB assembly into the bracket and install the two screws to secure the
front audio and USB assembly to the bracket.
9. Install the front audio and USB assembly bracket into the chassis and align the screw hole in the
bracket with the corresponding hole in the chassis.
10. Install the screw to secure the bracket to the chassis.
11. Reconnect the front audio and USB assembly cables to the front audio connector and the front USB
connector on the system board. See “Locating parts on the system board” on page 77.
12. To complete the replacement, go to “Completing the parts replacement” on page 112.
Replacing the internal speaker
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide , go to:
http://support.lenovo.com
This section provides instructions on how to replace the internal speaker.
Note: The internal speaker is only available in some models.
To replace the internal speaker, do the following:
108
ThinkCentre Hardware Maintenance Manual