Lenovo 0870A6U, User Manual

Page: 56 / 100

This section provides instructions on how to replace the card reader.
Note: The card reader is available only in some models.
To replace the card reader, do the following:
1. Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your
computer and gently lay it down so that the screen is against the surface and
the cover is facing up.
3. Remove the computer cover. See “Removing the computer cover” on page 16.
4.
Locate the card reader in the computer. See “Component locations” on page 12.
5. Disconnect the USB cable from the card reader.
6.
Remove the two screws that secure the card reader and then lift the card reader
out of the computer.
7. Align the screw holes in the new card reader with those in the computer and
then install the two screws to secure the card reader.
8.
Connect the USB cable to the new card reader.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v
To complete the installation or replacement, go to “Completing the parts
replacement” on page 55.
Figure 34. Removing the card reader
48
User Guide