Page 39
XP17
Sound Reduction (SR1) Cover
MIDDLE CABLE TIE
BASE
BOTTOM CABLE TIE
SUCTION
GROMMET
LEFT SIDE
COVER
RIGHT SIDE
COVER
DISCHARGE
GROMMET
LEFT TOP CAP
RIGHT TOP
CAP
TOP CABLE TIE
DISASSEMBLY PROCEDURE
The illustration to the right identifies the sound reduction
parts. Disassembly procedure is as follows:
4. Remove top, middle and bottom cable ties.
5. Remove top caps.
6. Remove SR1 left and right side covers.
7. Remove suction grommet.
8. Remove discharge grommet.
ASSEMBLY PROCEDURE
The illustration to the right identifies the sound reduction
parts. Assembly procedure is as follows:
1. Remove discharge grommet.
2. Install suction grommet.
3. Install SR1 left and right side covers.
4. Fasten new bottom cable tie.
5. Install discharge grommet.
6. Install top caps.
7. Fasten new top cable tie.
8. Fasten new middle cable tie.
Cable ties are not reusable. Order Cable Tie Kit, Lennox Catalog Number
17W77. Kit will included the following three cable ties:
1. Top and middle cable tie are 36 inches in circumference.
2. Bottom cable tie is 60 inches in circumference.
Gun setting for cable ties should be set to 6 @ 70 PSI. Tension is approximately
51 pounds force.
Figure 17. Sound Reduction Cover Parts and Disassembly (Used on Some Models)
Summary of Contents for iComfort SL18XC1 Series
