Page 60
XP17
Removing and Installing Panels
REMOVE 4 SCREWS TO
REMOVE PANEL FOR
ACCESSING COMPRESSOR
AND CONTROLS.
POSITION PANEL WITH HOLES
ALIGNED; INSTALL SCREWS
AND TIGHTEN.
ACCESS PANEL REMOVAL
Removal and reinstallation of the ac
cess panel is as illustrated.
Detail A
Detail C
Detail B
ROTATE IN THIS DIRECTION; THEN
DOWN TO REMOVE PANEL
SCREW
HOLES
LIP
PANEL SHOWN SLIGHTLY ROTATED TO ALLOW TOP TAB TO EXIT (OR ENTER) TOP SLOT
FOR REMOVING (OR INSTALLING) PANEL.
MAINTAIN MINIMUM PANEL ANGLE (AS CLOSE TO PARALLEL
WITH THE UNIT AS POSSIBLE) WHILE INSTALLING PANEL.
PREFERRED
ANGLE FOR
INSTALLATION
Detail D
ANGLE MAY BE
TOO EXTREME
HOLD DOOR FIRMLY ALONG
THE HINGED SIDE TO MAINTAIN
FULLY-ENGAGED TABS
LOUVERED PANEL REMOVAL
Remove the louvered panels as follows:
1.
Remove two screws, allowing the panel to swing open slightly.
2.
Hold the panel firmly throughout this procedure. Rotate bottom corner of panel
away from hinged corner post until lower three tabs clear the slots as illustrated
in
detail B.
3.
Move panel down until lip of upper tab clears the top slot in corner post as illus
trated in
detail A
.
LOUVERED PANEL INSTALLATION
Position the panel almost parallel with the unit as illustrated in
detail D
with the screw
side as close to the unit as possible. Then, in a continuous motion:
1. Slightly rotate and guide the lip of top tab inward as illustrated in
detail A
and
C
;
then upward into the top slot of the hinge corner post.
2. Rotate panel to vertical to fully engage all tabs.
3. Holding the panel's hinged side firmly in place, close the right-hand side of the
panel, aligning the screw holes.
4. When panel is correctly positioned and aligned, insert the screws and tighten
.
PANELS
ACCESS AND LOUVERED
IMPORTANT —
Do not allow panels to hang on unit by top tab. Tab is for align
ment and not designed to support weight of panel.
IMPORTANT —
To help stabilize an outdoor unit, some installations may require
strapping the unit to the pad using brackets and anchors commonly available in the
marketplace.
To prevent personal injury, or damage to panels, unit or structure, be sure to ob
serve the following:
While installing or servicing this unit, carefully stow all removed panels out of the
way, so that the panels will not cause injury to personnel, nor cause damage to
objects or structures nearby, nor will the panels be subjected to damage (e.g., be
ing bent or scratched).
While handling or stowing the panels, consider any weather conditions, especially
windy conditions, that may cause panels to be blown around and battered.
WARNING
Figure 37. Removing and Installing Panels
Summary of Contents for iComfort SL18XC1 Series
