Lenel m3000, Installation Manual, Page: 15 / 118

M3000 Installation Guide
15
CHAPTER 2
Installation, Planning, and Mounting
The following is a basic outline for installing and setting up your M3000 system. Some steps may
have been done for you depending on what you ordered. Some steps are optional, depending on the
additional equipment you plan to use. These steps are noted.
• WARNING! • Do not apply power to any component until the installation is complete.
Damage to components may occur if power is incorrectly applied.
1.
Determine the cable clamps needed and obtain them before starting the installation.
During the installation, remember to:
•
Label all connections/cables for ease of maintenance.
•
Leave enough slack in the wiring so the cables can be “dressed”. This minimizes
interference during board removal or replacement.
2.
Unpack your system. Refer to Introduction on page 9 .
3.
Mount the enclosure. Refer to Mounting on page 17 .
4.
Connect AC power to the power supply. Refer to Connecting the AC Input Power to the M3000
on page 25 .
5.
Mount and install the battery backup. Refer to Installing the Battery Backup, AC Fail, and Low
Battery on page 27 .
6.
Wire up the Power/Communications board. Be sure to configure and verify the switch settings.
Refer to
Power/Communications Board on page 23 .
7.
If using networked controllers, verify that your network is up and running.
8.
Install and wire up the PXNplus CPU board. Be sure to configure and verify the jumpers. If this
is a network controller, plug in the network cable. Refer to
PXNplus CPU Board on page 31 .
9.
Install the reader board(s) into the enclosure and wire up the readers to the controller. Be sure to
configure and verify the switch settings, jumpers, and/or resistor packs. Refer to
Reader
Processing Boards on page 37 .
10.
If using digital inputs (DIs), insert the DI board into the enclosure and wire the DIs to the board.
Be sure to configure and verify the switch settings. Refer to
20DI Board on page 71 .
11.
If using digital outputs (DOs), insert the DO board into the enclosure and wire the DOs to the
board. Be sure to configure and verify the switch settings. Refer to
16DO and 16DOR Boards on
page 74 .
12.
Test the wiring before you apply power. Refer to Pre-Power Up Testing on page 79 .