Lenel m3000, Installation Manual, Page: 33 / 118

M3000 Installation Guide
33
Pins and Jumpers
Pins and Jumpers
Inserting and Removing the PXNplus Board
Inserting the PXNplus Board
Caution: Follow standard static prevention procedures. Refer to Electrostatic
Discharge (ESD) Precaution on page 16 .
1.
Disconnect power and battery backup power.
Note: When re-inserting the CPU board, the J8 connector MUST be connected at all times to
comply with CE requirements for use in the European Union. Refer to figure
Location
and Grounding of the Power/Communications and CPU Board on page 95 .
2.
Insert the CPU board into the controller.
3.
Attach the network cable.
Removing the PXNplus Board
Caution: Follow standard static prevention procedures. Refer to Electrostatic
Discharge (ESD) Precaution on page 16 .
1.
To safely shut down the controller operating system, refer to the
Safe Shutdown Procedure for
the PXNplus CPU Board
on page 34 .
2.
Disconnect power and battery backup power.
3.
Remove any connected cables.
General Purpose Pins
Pins Shorting these pins...
JP2
Boot Mode
This function is for manufacturing and catastrophic failure recovery
only!
JP3
Shutdown requested
See Safe Shutdown Procedure for the PXNplus CPU Board on page 34 .
JP4
Restore Defaults
Returns the configuration to the factory defaults:
•
Primary Connection Type: Ethernet
•
IP Address: 192.168.6.6
•
Mask: 255.255.255.0
•
Gateway: 192.168.6.1
Short JP4 for a minimum of five (5) seconds.
Enables the Integrated Configuration Tool (ICT). For more information, refer
to
Disable/Enable the Integrated Configuration Tool (ICT) on page 89 .
JP6
Hardware Reset
Reboots the CPU board without properly shutting down the application.
The PXNplus board runs an operating system just like a computer. Shorting
JP6 is like pressing the Off button on your computer without using the “Shut
down” feature. The controller shuts down but not in a clean way.