Lenel m3000, Installation Manual, Page: 88 / 118

Controller Firmware Tools
88
M3000 Installation Guide
Controller Parameters Menu > Secondary Network Form
If controller has a Dual Network Interface Card (NIC) installed, a Primary Network tab and a
Secondary Network tab are available from the Controller Parameters menu.
Secondary Network Form
To configure the Dual NIC:
1.
Click the Controller Parameters menu and select the Primary Network form.
2.
On the Primary Network form, select the Enable Secondary check box .
3.
Click the Secondary Network tab.
4.
In the Controller Information area of the Secondary Network form, set the static IP address or
select DHCP (refer to the instructions for the Controller Parameters Menu > Primary Network
Form on page 86 .)
5.
Click Save .
6.
If this completes your controller configuration, click Reset Controller .
Controller Parameters Menu > Other Parameters Form
Access the Controller Parameters menu and use the Other Parameters form to enable/disable the ICT,
enable/disable Telnet/FTP, and to select the door contact/request to exit (REX) input source options.
Other Parameters Form