To setup the Decoder please review “Configuring terminal program Step One” earlier
in the manual.
This will instruct you on set-up and configuration of the Microsoft® Windows XP
Pro® program, “HyperTerminal®” included with all Microsoft® OS programs, but
the many Linux and Apple® based terminal programs are also quite serviceable for this
function.
Once your terminal is setup correctly you can now program the defaults into the
Decoder.
Decoder Terminal Operation
To start communication between the Leivio unit and the connected computer, press
the “TERM” button on the Leivio front panel and hold it for 2 seconds. THEN
while
holding the term button down, you press and hold for 1 second the “RESET” switch
on the FRONT of the unit.
You should then see something like the following fig. 15 image;
Figure 13 - Decoder Terminal Screen
Basically with the decoder all you need to program is the IP address of the unit, and/or
its multicast address along with the local IP mask and gateway address.
Then save those defaults with menu item 20, and restart the unit. You are finished with
set-up for the unit at this point.
24