53
Before each use and after unusual occur-
rences, the
carrying handle (5)
that is
used for fastening the safety rope must be
inspected by an individual with expertise
in this area.
The
carrying handle (5) is not
permitted to exhibit any cracks, corrosion,
notches or other material faults.
The additional weights must be reliably se-
cured with the
safety clamps (1 each at the
front and rear)
provided for this purpose.
In cases of power mains failure, during
work interruptions or when cooling down,
you must
swivel the hot-air blowers (10)
into park position and allow them to engage
there.
While doing so, take care to ensure that the
lock of the
hot-air blowers (15)
engages!
Caution!
Secure the hot air welder with the
carrying handle (5) only!
Caution!
The welder is never permitted to be fastened to single hitching points which allow ropes
to sag! The connection equipment must always be set to as short a length as possible in order
to completely eliminate the chance of falling over the edge of the parapet.
Caution!
The effects of gravity bring with them the danger of uncontrolled falling or sinking. The
securing point is not designed to withstand the shock-like stress of an abrupt fall!
Contact the manufacturer without fail should uncertainties arise during installation or operation.
Safety clamp
Art. No. 155.577
1
10
15
