Leica mojo 3D, User Manual

Page: 43 / 378

Leica mojo3D, Running the mojo3D for the First Time 43
Section controller
implement mode
setup,
step-by-step 1. On the section controller/implement mode setup screen, in the list at the left of
the screen, tap to select section controller type :
• None : section control is disabled.
• On Screen : sections are shown on screen turning on & off, but no physical
control of sections is possible.
• Single Section : a maximum of one section can be setup for the vehicle. This
section is automatically controlled with physical output on the port expansion
cable.
• Leica AS400 : multiple sections are automatically controlled via the Leica
AS400 section controller hardware, supplied with the multi-section control kit.

If Direct Section Control has been unlocked, other Section Controllers will
appear in the list.
2. Tap to select implement mode :
• Sprayer Mode : is used for most situations, this allows the section control to
be optimally setup for general applications.
• Planter Mode : optimises the system for operating a planter and if selected,
reverses the polarity of the Leica AS400 normal operation.
3. Tap to continue.
Master input
source setup,
step-by-step 1. On the master input source screen, in the list at the left of the screen, tap to
select the master input source .
2. In the list at the right of the screen, tap to select the input mode .