33
the curve of the wheel holder is the opposite of the first picture. The floorboards should be set
at their highest position as well, for these bikes.
This last picture (below) shows the setup for
the new ‘Ultra Low’. This bike does not come
with rear floorboards, much like the ‘Street
Glide’, so Harley or aftermarket boards MUST
be installed!
In order for the ‘LOW’ to work as well as other
bikes, we have to use our adjustable wheel
holders. It may be hard to see here, but we
move the wheel axle up to a second hole (1),
and the big axle at the top is set at the lower
hole (2). These two changes make the legs
shorter to offset the low height of the bike.
The floorboard needs to be in the highest hole.
The bolts that orient the wheel holder need to
be in the third and fifth hole from the back.
They also need to be threaded through the hole
that is second from the back on the wheel holder (3). If you told us you have an ‘Ultra Low’
this is how we would configure the system before shipping. We just furnish this info to
document the setup.
IF YOUR BIKE FITS ONE OF THE THREE SCENARIOS WE HAVE DISCUSSED
ABOVE, IGNORE THE NEXT SECTION! WE DO EVERYTHING WE CAN TO SET THE
SYSTEM UP BEFORE SHIPPING. IF YOU ARE NOT SURE, PLEASE CONTACT US
BEFORE ADJUSTING THE SETTINGS OUTLINED BELOW! IF YOU HAVE A
REMOVEABLE LOWERING KIT INSTALLED, YOU MAY WISH TO CONSIDER
REMOVING IT AS THE NEED SHOULD BE REDUCED SIGNIFICANTLY BY THE
LEGUP SYSTEM.
Summary of Contents for LandinGear Generation II
Page 2: ...2 ...
Page 9: ...9 Pin Out for Handlebar Control Box Plugs ...
Page 40: ...40 ILLUSTRATIONS ...
