19
The last thing we need to do is
create a small notch for the wires to
get through when the bag is closed.
We use a rotary burr, but you could
use a file or a small saw, to cut the
notch you see here.
What we want to have is a notch
about 3/8” wide by about 3/8” deep.
This small slot will have no
negative bearing on the weather-
tight nature of the bag, but it will
keep the wire from being hurt as
you open and close the bag over
time.
At the top of the bag, about 1” to
the left of the bail nut (the bolt that
holds the bag on) is where you want to place the relief. A bit left or right makes little difference,
but this wire goes down into a relief cut in the top of the compressor cover, so the more accurate
you are here, the better!
Make sure that the wire, when placed into the notch, as at or below the top surface of the bag,
and you are go to go!
Skip the next section on ‘Soft Bags’ and go to ‘Install the Compressor (Hard Bags)’.
Summary of Contents for LandinGear Generation II
Page 2: ...2 ...
Page 9: ...9 Pin Out for Handlebar Control Box Plugs ...
Page 40: ...40 ILLUSTRATIONS ...
