Page 11
CHANGING YOUR FLUSH-MOUNT CAMERA (FC) HEIGHT (OPTIONAL, CONTINUED)
6. Carefully place the removed camera panel
(with the HuddleSHOT FC still attached to it)
facedown onto an appropriate work surface.
7. Use power driver, #2 Phillips bit, and remove
(4x) 10-32 x ½” screws from the camera panel
as shown. (
FIGURE H
)
8. Carefully remove the camera from the panel,
rotate the camera 180º, and use the (4x)
screws from the previous step to reattach it
upside-down as shown. (
FIGURE J
)
Back of
Camera
Panel
NOTE
: The (4x)
10-32 x ½” screws
are shown in black
for clarity.
FIGURE H
NOTE
: With the camera reattached, carefully position the panel as shown and verify the microphones
on your camera are in the following position. (
FIGURE K
)
FIGURE K
FIGURE J
Carefully rotate your camera 180º,
and then reattach it to the panel
using the same (4x) screws.
Correct microphone position on the reattached camera.
Back of
Camera
Panel
Front of Camera Panel
9. Use a power driver, #2 Phillips bit, and the (6x) 10-32 x ½” screws from step 5 to reattach the
camera and panel assembly to your cart.
10. Reinstall Lever Lock brackets, 10” Lever Lock plates (B), 2” channels (C), devices, cables, and
cable management as necessary.
