Janu
ary 201
9
Legrand PDU User Guide 417
Resetting to Factory Defaults
The following commands restore all settings of the Legrand PDU to factory defaults.
To reset Legrand PDU settings after login, use either command:
#
reset factorydefaults
-- OR --
#
reset factorydefaults
/y
To reset Legrand PDU settings before login:
Username:
factorydefaults
See
Using the CLI Command
(on page 465) for details.
Network Troubleshooting
The Legrand PDU provides 4 diagnostic commands for troubleshooting network problems:
nslookup
,
netstat
,
ping
, and
traceroute
. The diagnostic commands function as corresponding Linux commands and can get
corresponding Linux outputs.
Entering Diagnostic Mode
Diagnostic commands function in the diagnostic mode only.
To enter the diagnostic mode:
1. Enter either of the following modes:
Administrator mode: The # prompt is displayed.
User mode: The > prompt is displayed.
2. Type
diag
and press Enter. The diag# or diag> prompt appears, indicating that you have entered the
diagnostic mode.
3. Now you can type any diagnostic commands for troubleshooting.
Quitting Diagnostic Mode
To quit the diagnostic mode, use this command:
diag>
exit
The # or > prompt appears after pressing Enter, indicating that you have entered the administrator or user
mode. See
Different CLI Modes and Prompts
(on page 296).
Diagnostic Commands
The diagnostic command syntax varies from command to command.