Janu
ary 201
9
334 Legrand PDU User Guide
Changing the LAN Duplex Mode
This command determines the LAN interface duplex mode.
config:#
network ethernet <ETH> duplexMode <mode>
Variables:
<ETH> is one of the options --
eth1
or eth2
.
Option
Description
eth1 ETH1
port
eth2 ETH2
port
<mode> is one of the modes:
auto
,
half
or
full
.
Option
Description
auto
The Legrand PDU selects the optimum
transmission mode through auto-negotiation.
half Half
duplex:
Data is transmitted in one direction (to or from the
Legrand PDU) at a time.
full Full
duplex:
Data is transmitted in both directions
simultaneously.
Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier (SSID), authentication method,
Pre-Shared Key (PSK), and Basic Service Set Identifier (BSSID) after the wireless networking mode is
enabled.
A wireless configuration command begins with
network wireless
.
Note: If current networking mode is not wireless, the SSID, PSK and BSSID values are not applied until the
networking mode is changed to "wireless." In addition, a message appears, indicating that the active network
interface is not wireless.
Setting the SSID
This command specifies the SSID string.
config:#
network wireless SSID <ssid>
Variables:
<ssid> is the name of the wireless access point, which consists of:
- Up to 32 ASCII characters
- No spaces
- ASCII codes 0x20 ~ 0x7E
