LEGRAND 0 026 72, Manual

Page: 16 / 29

16/29
Technical data sheet: S000114123EN-1 Updated: Created: 18/01/2021
Cat. No(s): 0 026 72/73/74/76/78/79
KNX controller multi-application DIN
7 . COMMUNICATION OBJECTS (continued)
7 .7 "Switch" parameter (continued)
7 .7 .2 "A1 - Function" parameter (continued)
7 .7 .2 .3 "A1 - Sweep" parameter (continued)
Blink off time *300ms …1sec
How long the lights shall be switched off in the period.
Wait time after blinks (sec)
0…
*30
…255
How long the lights shall be switched on after sweep blink finished.
7 .7 .2 .4 "A1 - Scene" parameter
For more information please look scene, page 7 .
7 .8 "Blind" parameter
7 .8 .1 "A/B – General" parameter
In this parameter page, general settings for blinds (AC blind or DC blind)
are explained. Parameters for both types is the same.
Mode of operation
*venetian blind
roller shutter / awning
This parameter defines the operating of the output group. Each
output of the group can be configured independently for the drive
type. The communication object and parameters for the respective
outputs differ on the mode of operation. The ETS adapts the
parameters and communication object for all group.
• Set the parameter to “venetian blind”:
In this mode, there are also parameters and objects for slat operation.
• Set the parameter to “roller shutter / awning”:
In this mode, there is no slat control so slat parameters and object
automatically hiding by the ETS3.
7 . COMMUNICATION OBJECTS (continued)
7 .8 "Blind" parameter (continued)
7 .8 .1 "A/B – General" parameter (continued)
Behavior after ETS programming
or after ETS reset
Behavior bus voltage failure
*no reaction
up
down
stop
position 1,2,3,4
approach position
This parameter can be used to configure the blind behavior after ETS
programming.
• Set the parameter to “ no reaction ”:
The output group switch remain in their current state.
• Set the parameter to “
up
”:
After the ETS programming, the actuator raises the blind.
• Set the parameter to “
down
”:
After the ETS programming, the actuator lowers the blind.
• Set the parameter to “ stop ”:
After the ETS programming, the actuator stops the blind movement.
• Set the parameter to “ position 1,2,3,4 ”:
The blind move to a present position. The positions are set in the “X -
Position/Present” tabs .
• Set the parameter to “approach position”;
The blind can travel to an approach position specified by other
parameters. Other parameters are;
Position height in [0…100]
(0% = top; 100% = button)
Position slat in [0…100]
(0% = top; 100% = button) .
This parameters are configured the blind height and slat position. If
the “ Mode of operation ” is selected “ venetian blind ”, “ Position slat
in [0…100] ” parameters are visible.
Behavior bus voltage return
*no reaction
up
down
stop
This parameter can be used to configure the blind behavior after bus
voltage return.
• Set the parameter to “no reaction”:
The output group switch remain in their current state.
• Set the parameter to “up”/
After the bus voltage return, the actuator raises the blind.
• Set the parameter to “down”:
After the bus voltage return, the actuator lowers the blind.
• Set the parameter to “stop”:
After the ETS programming, the actuator stops the blind movement.
CONTENTS