8
ASSEMBLY
STEP 5
Remove remaining packaging and any protective film.
STEP 6
Plug the base into an electrical power source. Note: An electrical
surge protection device is recommended, but not included.
STEP 8
Lower base to flat position.
STEP 7
Install 3-AAA batteries in the remote control (FIGURE 3).
Operate remote control to verify base functions properly. If base
does not operate, see the Troubleshooting section.
Remove battery
compartment door by
lifting tab. Insert tab
in slots and snap in to
replace.
FIGURE 3
TAB
BATTERY
COMPARTMENT
DOOR
POSITIVE (+)
END
POSITIVE (+)
END
