10
REMOTE CONTROL FUNCTION
REMOTE CONTROL REQUIRES THREE (3) AAA SIZE BATTERIES (INCLUDED).
NOTE
SNORE BUTTON
Press and hold
to raise head to the
preprogrammed position. Head will
automatically lower to flat after 15
minutes.
*To program a position, adjust base to
desired position, press and hold the
set
button
until the massage motors and
underbed light turn on and off, then
press and hold the
Snore button
until
the massage motors turn on and off.
SET BUTTON
Press and hold to program M1, M2 and
Snore presets.
M1 BUTTON
Press and hold
to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the
set
button
until the massage motors and
underbed light turn on and off, then
press and hold the
M1 button
until the
massage motors turn on and off.
M2 BUTTON
Press and hold
to adjust base to the
programmed position.
*To program a position, adjust base to
desired position, press and hold the
set
button
until the massage motors and
underbed light turn on and off, then
press and hold the
M2 button
until the
massage motors turn on and off.
HEAD MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
FOOT MASSAGE UP/DOWN BUTTON
Press to increase or decrease massage
intensity. Massage has 3 speeds:
Low, medium and high. Massage will
automatically shut off after 15 minutes.
MASSAGE ON/OFF BUTTON
Press “on” to turn both massage motors
on. Press “off” to turn both massage
motors off.
FOOT UP/DOWN BUTTON
Press and hold
to raise or lower the foot
section.
FLAT BUTTON
Press and hold
to lower the base to the
level position.
HEAD UP/DOWN BUTTON
Press and hold to raise or lower the head
section.
LUMBAR UP/DOWN BUTTON
Press and hold to raise or lower the
lumbar section.
UNDERBED LIGHT BUTTON
Press to turn underbed light on. Press
again to turn underbed light off.
LOCK BUTTON
Press to lock remote control. Press again
to unlock remote control.
PRESS & HOLD TO ONE TOUCH
Note: If using 2 remotes to operate 1 or more bases, both remotes must be set to the same “press & hold” or “press & touch” mode.
To change remote control functions from “press and hold” to “one touch” (“one touch” = press and release), simultaneously press
the
HEAD MASSAGE DOWN
and
FOOT MASSAGE DOWN
buttons for 5 seconds. The massage motor and underbed light
will turn on
and off confirming the change. Your base is now set to “one touch.”
When in “one touch” mode:
M1, M2, and Snore buttons
Press and release (one touch) button. Base will adjust to the programmed position. Press any other button to stop the base during movement.
Flat button
Press and release (one touch) button. Base will shut off massage motor, if active, and adjust base to level position. Press any other
button to stop the base during movement.
To revert back to
factory settings
, simultaneously press and hold the
SET
button and the
FLAT
button for 5 seconds. The massage
motor will turn on and off confirming the change. Your base is now set to factory settings.
Note: M1, M2, and Snore positions will
revert to factory preprogrammed positions.
