WaveSurfer Accessory
connected with a combination other than that shown above.
However, if the positive (+) and negative (-) terminals are
connected incorrectly, this may cause an electric shock, a fire, or a
malfunction.
•
Do not connect a cable or cord, such as AC cable other than
that intended for operation stated in this instruction manual
to the BATTERY or CHARGE CONTROL connector of this
product.
Doing so may cause an electric shock, a fire, or a malfunction.
•
Always use the proper 3-pin power cord suitable for the power
voltage, which is supplied with this product.
•
If this product is not used, turn OFF the POWER switch of
this product, hold the plug firmly, and disconnect the power
cord from the outlet.
Failure to do so may cause a malfunction, an electric shock, or a
fire.
•
Always operate this product within a specified AC power
voltage range.
If the input current is excessive, the internal fuse is blown up to
shutdown the power. At this time, to recover the BATTERY
CHARGER, it is absolutely necessary to replace the internal fuse
and make the adjustment. Ask LeCroy Corporation to repair the
defective BATTERY CHARGER.
•
Keep product surfaces clean and dry.
CLEANING
The outside of the BATTERY CHARGER hardware should be
cleaned with a soft cloth dampened with either deionized / distilled
water or isopropyl alcohol. Allow the surface to dry completely
before returning the instrument to service.
USE AND MAINTENANCE
The BATTERY CHARGER is a high quality, precision instrument.
To maintain accuracy, mechanical shock should be avoided, as well
as damage to the cables through excessive bending. All maintenance
and component replacement should be referred to qualified
personnel.
5
