WaveSurfer Accessory
Overview
This product is an optional unit that is specially designed for the
oscilloscope and is intended to charge the optional BATTERY
PACK.
This instruction manual describes how to connect this product to the
BATTERY PACK and how to charge the BATTERY PACK.
Before using this product immediately after you have purchased it,
thoroughly read this instruction manual to fully understand its
contents.
Configuration
When charging the BATTERY PACK, the BATTERY PACK is
connected to the BATTERY CHARGER (WS-BATT-CHRG) with
the CHARGE CONTROL cable (supplied with the BATTERY
CHARGER) and DC OUT cable as shown in Figure 1 below to
charge the BATTERY PACK.
The charge output is output from the BATTERY CHARGER to the
DC OUT (indicated on the label) connector of the BATTERY PACK
through the DC OUT cable during charging. Additionally, the
control signal is input from the BATTERY CHARGER to the
CHARGE CONTROL (indicated on the label) connector of the
BATTERY CHARGER.
BATTERY PACK
(WS-BATTERY)
DC OUT
CHARGE
CONTROL
BATTERY CHARGER
(WS-BATT-CHRG)
BATTERY
CHARGE CONTROL
CHARGE CONTROL cable
DC OUT cable
Figure 1 Configuration for Charging of BATTERY PACK
7