BATTERY CHARGER User's Manual
•
Connect and disconnect properly
.
Do not disconnect the CHARGE CONTROL cable and/or the DC
OUT cable of the BATTERY PACK while the BATTERY PACK
is charged.
Doing so may cause the product to malfunction corrupted.
•
Do not use in wet/damp or explosive atmospheres.
•
For indoor use only.
The BATTERY CHARGER is intended for indoor use and should
Be operated in a clean, dry, environment.
•
Do not operate with suspected failures.
Do not use BATTERY CHARGER if any part is damaged. All
maintenance should be referred to qualified service personnel.
•
Before mounting this product, always check the connecting
procedures stated in this instruction manual.
•
For safety reasons, make sure to turn off the power switch of
the product before carrying out wiring of the connectors and
cables. Also make sure to turn off the power button before
connecting to the input power source.
Turning on/off the power switch controls the on/off state of the
output.
•
Always use the supplied CHARGE CONTROL cable.
If a cable other than the supplied CHARGE CONTROL cable,
this may cause an electric shock, a fire, or a malfunction.
•
Stop use if the BATTERY PACK is not charged fully within
the normal charging times.
If the time required to charge the BATTERY PACK is
significantly longer than the “normal” charging times shown in
the specification section of the BATTERY PACK User’s Manual,
this could indicate a problem with the BATTERY PACK or that
the BATTERY PACK has exceeded the nominal battery life. If
this occurs, please contact LeCroy sales or service office.
•
Connect the positive (+) and negative (-) terminals of the DC
OUT cable of the optional BATTERY PACK of the
oscilloscope to the positive (+) and negative (-) terminals of
this product.
The connector shape is so designed that the terminals cannot be
4
