11. VECTOR DISPLAY
107
11.7
Configuring the 5 Bar Display
To configure the 5 bar display, press F•4 5BAR SETUP on the vector menu. You can set the
signal display order and the scale units.
F•4 5BAR SETUP appears when DISPLAY is set to 5BAR.
For information on the DISPLAY setting, see section 11.6, “Switching between the Vector and 5-Bar
Displays.”
11.7.1
5 Bar Display Explanation
The 5 bar display appears when F•1 DISPLAY is set to 5BAR.
On the 5 bar display, the positive and negative peak levels are displayed simultaneously.
The levels are typically displayed in cyan, but portions that exceed their limits are displayed
in red.
Figure 11-8 5 bar display
1 Error
Counter
The error counter, the current time, and the elapsed time appear here.
2 Y
The luminance signal level appears here.
The levels that fall outside of the range you set using Luminance Error in the status
display are displayed in red.
3
G, B, R
The levels after converting the YC
B
C
R
signal into a GBR signal appear here.
You can use F•1 SEQUENCE to change the signal order to RGB. The levels that fall
outside of the range that you set using Gamut Error on the status screen are displayed
in red.
