Leader Evaporator Springtech MicRO Reverse Osmosis System Manual YEAR: 2017
Page: 14
Concentrate and Permeate Outflow Connections
The connections to the outflow side of the concentrate and permeate flow meters are to ½” couplers located at the
top of the meters. The connections below describe one method connecting to the flow meters. If you are frequently
going to move the system and want to have added flexibility, use ½” “F” style quick connectors on the tops of the flow
meters and ½” “C” style quick couplers on the ends of the hoses to be connected to the flow meters. The method
below describes more permanent connection.
In order to assemble the connections you will need (all sold separately);
Two ½” PVC plastic to iron adapters,
Two (minimum) ½” Stainless Steel Band clamp,
½” ID braided food grade hose with length to make the connections for the Permeate and Concentrate tank.
The length of each hose should be sufficient to reach the wash tank.
Concentrate Flow Meter Connection
1.
Teflon tape the threaded end of a ½” PVC plastic to iron adapter.
2.
Thread the adapter into the top rear of the concentrate flow meter. The
flow meter is on the left hand side of the front panel. Tighten the
adapter.
3.
Cut a length of ½” ID braided hose of sufficient length to connect to the
concentrate flow meter outflow connector to the concentrate tank or
the wash tank whichever length is greater.
4.
Place at least one ½” stainless steel band clamp over the hose.
5.
Slide the hose onto the barbed end of the ½” PVC plastic to iron adapter.
6.
Position the stainless steel band clamp(s) over the hose on the adapter
and tighten the band clamps.
7.
Place the open end of the hose into the concentrate tank.
