Leader Evaporator Springtech MicRO Reverse Osmosis System Manual YEAR: 2017
Page: 12
The following illustrates a generalized layout for all possible flows with the Springtech RO system. The drawing shows
tank connections to the system. Flows as shown will not all be active at the same time. To determine which flows are
active reference later sections in the document detailing the cycles (concentrate, recirculation, desugar, rinse and
wash). Dependent on the location, other arrangements are likely. It is beyond the scope of this document to
recommend the best layout for all situations. It is recommended you contact your LEADER EVAPORATOR sales person
or your local Distributor / Dealer for assistance in deciding the correct tanks and layout for your needs.
Required Flows Diagram
Green lines indicate possible flows from the Concentrate flow meter output.
Brown lines indicate possible flows from the Permeate flow meter output.
Blue line indicates flow from the Wash tank.
Black line from Sap Storage is flow of raw sap
Strainer Connection
Plumbing from the supply tanks is recommended to be 1” ID. A “Y-“strainer is not supplied but is highly
recommended. The strainer will prevent large contaminants from reaching the system. The connection can be made
as follows:
1.
Identify the flow direction through the strainer,. There is an
arrow on top of the strainer which shows the direction of
flow. The input side pushes the liquid through the strainer
prior to it going into the system. Additionally, when mounting
the strainer, the spigot should be on top as it will need to be
opened to bleed air from the system,
2.
Install a valve before and after the Y strainer so the strainer
can be removed and cleaned.
