mc²96 Installation & Service Guide
Version: 1.0/3
43/65
5. Service Procedures
5.5
Replacing a Fader
An individual fader unit can be replaced by removing the Fader Panel from the console. Note that the illustrations
below show how to do this on a mc
2
36 MKI. However, the same procedure can be performed on a mc²96
console.
In our example, it is the left-hand fader with the panel face-up (Fader Number 1), which is being replaced:
Panel Face-up
Panel Face-down
DO NOT
attempt to open the frame without first disconnecting the mains supply.
1.
Remove the Fader Panel from the console frame as described
, and lay it it face-down on a piece
of foam, or similar ESD-proof protective material, away from the console. Take care not to touch the flat foil
cables.
2.
Using a small flat-blade screwdriver, release the catches to disconnect the fader unit cables - there are
two cables to release:
3.
Turn the panel face-up and remove the fader cap.
4.
Remove the two screws holding the fader unit in place (using a T10 Torx driver):