mc²96 Installation & Service Guide
Version: 1.0/3
38/65
5. Service Procedures
5.3
Replacing a Panel
Each control surface panel can be replaced without affecting the rest of the system. Please see
for a description of the panel options. To replace a lower panel, you must
first lift the upper panel.
5.3.1
Replacing an Upper Panel
DO NOT
attempt to open the frame without first disconnecting the mains supply.
1.
Remove the screws at the bottom of the panel using a T20 Torx driver.
The number of screws vary depending on the panel type: channel bay panels have three screws, while the
central panel has four.
You should remove the screws completely and place them carefully to one side, so that they do not fall into the
frame when the panel is lifted. The springs beneath the panel will raise it slightly from the frame.
2.
Gently lift the panel using your fingers:
3.
Use the
to keep the upper panel in place while you work.
You can now continue on to step 4 (if replacing the upper panel), or skip