Lavry DA11, Manual

Page: 20 / 23

DA11 Operation
16
Peak output levels for DA11 Volume Settings:
Volume Setting
XLR Balanced Operation XLR Unbalanced Operation Headphone Level
56 24dBu 18dBu 18dBu
50 18dBu 12dBu 12dBu
--- --- --- ---
46 14dBu 8dBu 8dBu
--- --- --- ---
01 -31dBu -37dBu -37dBu
00 OFF OFF OFF
AES/EBU professional analog line levels:
Set to 56 for 24dBu balanced = 34.72V peak to peak = 12.28V rms
Set to 56 for 18dBu un-balanced = 17.36V peak to peak = 6.14V rms
A typical home power amp or powered speaker:
Set to 40 for 8dBu balanced = 5.6V peak to peak = 2V rms
Set to 46 for 8dBu unbalanced = 5.6V peak to peak = 2V rms
OPTIONAL INFRARED REMOTE
The DA11 is programmed to accept standard Philips RC5 TV infrared remote commands. This
means almost any Universal infrared remote control can be programmed to control the DA11. Be
sure to check the information on the universal remote package to confirm it works with Philips
TV’s. Follow the instructions that come with the universal remote, and program the remote using
the code from the instructions for a Philips TV. If the first code does not work correctly, there is
often more than one code available; so try a different code that is also for a Philips TV.
Once the universal remote is programmed, it controls the DA11 in the following manner:
1.) The “Mute” button is always active and immediately toggles the audio outputs of the DA11
“on” and “off.” Please note that this
does affect the headphone output and is therefore not the
same as the “output” function in Settings mode.
-
To indicate the “mute” function has been engaged, in Operating mode the two LED’s in the
IMAGE display will go dark unit the mute button is pressed again to un-mute the DA11. The mute
function can also be
turned “off” by operating the DA11’s front panel volume up/down switch.
2.) The current factory default is for the SAFE MODE to be disabled . If SAFE MODE is enabled,
a
ll other commands are “gated” to prevent accidental changes. The symbol “LE” appears in the
VOLUME display to indicate that the gate is “closed” and the DA11 will not accept infrared
commands other than Mute. Press and hold the number “0” button for a few seconds, and the
numerical volume setting will re-
appear to indicate that the “gate is open.” As long as the
numerical volume setting is displayed, the DA11 continues to accept remote commands. Please
also note that the “LE” indicates when the settings have been stored in memory. Please see
ENABLING or DISABLING SAFE MODE (below) for more information.
-
Pressing the “Mute” button also “opens the gate.” Once open, it is not necessary to press “0” to
access the other remote functions until the LE symbol appears in the Volume display.
For all of the following functions, it is assumed that SAFE MODE is disabled, or that the
“gate is open” so the numerical setting is visible in the VOLUME display.
3.) To raise or lower the volume setting, press the Volume Up or Volume Down button on the
remote. Similar to the front panel “up/down” switch, a single press of the remote button will
change the volume by one step, and holding the button will make the setting change continuously
until the button is released or the end of the adjustment range has been reached.