Installation and Setup
BLUEPOD TECHNICAL SERVICE
Tel: 1800 800 255 Email: [email protected]
Copyright Bluepod Coffee Co Pty Ltd
Page 10 of 12
LB3200 Colibri
DATE OF ISSUE: 27/01/2011
4. On the inside of the door are 2 buttons, the left button is the rinse button.
5. Ensure the display reads “Ready for use”. Press the rinse button; this will rinse the
mixing bowl and pipes as well as rinsing the filter in the coffee brew unit. You should
see hot water pouring out of the water spouts into the waste tray. Once it has stopped,
press again to repeat this process.
6. Remove the drip tray and clean. Lift the tray at the front and pull towards yourself. The
drip tray can be separated for cleaning by pressing the two release tabs located at the
rear of the tray.
Do not wash in a dishwasher,
this will damage the tray.
7. If your machine is benchtop mounted, remove rear used pod drawer. Empty, clean and
insert when LCD indicates. Refit drip tray making sure it is aligned properly.
8. If fitted, open the bottom cabinet using the round key.
9. Empty the white plastic used pod container which sits in the upper section of the
bottom cabinet, clean and replace.
10. Empty waste container, clean and replace making sure that the float and the drain hose
from the drip tray are both inside the waste bucket.
11. Remove yellow service key and store inside the machine, the small storage drawer is
ideal. Close and lock both top and bottom doors.
12. The machine will now self test and heat. Please wait for the LCD to show “Ready for
use”